![]() ![]() This manual is intended for software beginners who are familiar with the use of software and hope to be helpful to beginners. At the same time, led edit 2019 is perfectly combined with mainstream design software Auto, CAD, Coreldraw, Flash, and provides a powerful and convenient software for LED lighting. ③SD card did not format to FAT before copying effect files.Pixel led design software LedEdit-k v4.9.4 is our latest program editing software, compatible with Windows XP, Vista, Win7, Win8, Win10. ②The effect file in the SD card and the controller model do not match, please choose the correct controller model in LedEdit and then re-create the effect file *led. Question 1: After power, the T-1000S ERROR indicator has been flashing without display outputĪnswer: The ERROR indicator has been flashing means the controller did not read the card correctly, possible problems: The SD card in the controller can not be hot-swappable, plug the SD card every time, you must first disconnect the Type: SD card(suggest using high-speed SD card)īefore copy files to an SD card, The SD card must be formatted in FAT format “15_2.led” - NO.4 program for No.2 controller “02_2.led” - NO.3 program for No.2 controller “01_2.led” - NO.2 program for No.2 controller “00_2.led” - NO.1 program for No.2 controller “15_1.led” - NO.16 program for No.1 controller “02_1.led” - NO.3 program for No.1 controller ![]() “01_1.led” - NO.2 program for No.1 controller “00_1.led” - NO.1 program for No.1 controller Name of the program: ( The rule of how to name the programs) If you need to control a new IC type by the controller, the software code mode is the T-1000-IC model.Ħ. If you need to use RS485 signal you need to connect controller A interface with LED lamps A (DMX+), controller Bĥ. If the chip for LED is a double line chip with DAT and CLK, then need to be connected with DAT, CLK, andĤ. When the chip for LED is a single line chip just with data, then just needs to be connected with the DAT and GND of theĬontroller. T-1000S one TTL(SPI) signal and one RS485 signal port output, can control 2048 pixels/lamps;ģ. Multiple T-1000S controllers can be cascaded together and work synchronously.Ģ. NOTE: For the TTL(SPI) signal, the controller signal ground must connect to the LED ground directly. T-1000S must use the new software LedEdit 2012. When the T-1000S controls more than 512 lamps and less than 2048 lamps the frame rate will slow down automatically.Ģ. When the T-1000S controller control less than 512 lamps the frame rate can reach 30fps. Compatible with a single line or double line chips.ġ. Off-line(SD Card) control, playback content stored in the SD card.ĥ.T-1000S stores a maximum of 16 programs, copy multiple files to the SD card in order,Īfter formatting the SD card as “FAT” format.Ħ. Single-port output, can support 2048 pixels。Ĥ. Support the rules and special-shaped handle.ģ. ![]() 32-256 Gray level, Support software Gamma correction。Ģ. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2022
Categories |